W 950 Flexio
W 950 Flexio
19. Rectifying errors when working with the spray lance
Problem
No coating
material
emerges from
the nozzle
Coating
material drips
from the nozzle
Atomisation too
coarse
Cause
•
Nozzle clogged
•
Material volume setting turned
too far to the left
•
When trigger is not completely
pushed through, the feed pump
is not switched on
•
The control hose not inserted into
the grab handle
•
Control hose blocked or
damaged
•
Container empty
•
Suction hose or suction filter is
blocked
•
The suction hose is
disconnected from the basic
device
•
The suction hose is not in the
paint
•
Pull wire is disconnected or not
tight enough
•
The material hose is
disconnected from the spray
head or basic device
•
Pump is defect
•
Coating material assembly at air
cap, nozzle or needle
•
Nozzle loose
•
Nozzle seal worn
•
Nozzle worn
•
Pull wire is too tight
•
Material volume too large
Material volume setting turned
too far to the right
•
Nozzle contaminated
•
Viscosity of coating material too
high
•
Air filter heavily soiled
•
At high quantity of material,
narrow spray jet selected (white)
Remedy
➞ Clean
➞ Turn to the right
➞ Push trigger through
completely
➞ Insert the control hose
(fig.3,1)
➞ Clean or replace
➞ New paint container
➞ Clean
➞ Reattach the suction hose
➞ Immerse the suction hose
➞ Connect and tighten the
pull wire
➞ Reattach the material hose
➞ Please contact Wagner
Service
➞ Clean
➞ Union nut tighten
➞ Change
➞ Change
➞ Reduce tension
➞ Turn the material volume
setting to the left
➞ Clean
➞ Dilute further
➞ Change
➞ Switch to wide spray jet
(schwarz)
GB
D
47
47