Operation Of Ignition Switch - Sym ME20BW-COC Série Manuel D'utilisation

If there is something wrong with the ECU,
the warning light will light all the time.
 Fuel Meter:
The pointer in this meter shows how much
fuel remains in the tank.
 Voltmeter/time meter:
Display average voltage of battery or time.
Under the normal display status, press
"SET" button 0.5 second, it can switch
"VOLTAGE" display mode or "CLOCK"
display mode. In time display mode, when
Engine Oil Replacement Indicator
Engine oil replacement indicator light will illuminate when the vehicle is ridden for approx. 1,000 km,
which means the engine oil should be checked or replaced.
Key on and press the "M" button for at least two seconds after replacing the engine oil, engine oil
replacement indicator light will extinguish.
Mileage Setting:
Clock Setting:
Low fuel load warning light:
When there is a little fuel inside the tank, the warning light will be on.
Cooling temperature Indicator:
Indicates the engine cooling water temperature, engine cooling water temperature indicator if light,
should check the cooling water is sufficient and the fan motor is running
§OPERATION OF IGNITION SWITCH §
Long press "S" button
Total mileage
Short press "M"
Long press "S" button
Single mileage
Hour
Short press "M"
Minute (tens digit)
Short press "M"
Minute (units digit)
Short press "M"
Return to normal mode
9
the scooter is stationary , long press the
"MODE" button. more than 2 seconds,
then it enter the time setting MODE, at this
time press "MODE" button 1second, it can
switching over setting mode(Hour→
minutes tens digit→minute single digits).
Short press "SET" button once, figure add
1. In setting display mode, long press the
"MODE" button for more than 2 seconds, it
can leave the setting mode.
Switch the mileage
mileage value is
Short press "S"
Short press "S"
Short press "S"