Sym ME20BW-COC Série Manuel D'utilisation page 32

COOLING SYSTEM INSPECTION(For:ME20BW-COC/ME20BW-BRC)
(Check the cooling system for leakage)
1. Support vehicle with main stand on a level ground.
2. Check reserved tank from viewing window to
see if coolant level is between the upper limit
and lower limit mark.
3. Add coolant up to upper mark if coolant is close
to the lower mark.
(Check the cooling system for leakage)
• Check radiator and piping for leakage.
•
Check the ground where the vehicle is parked for water
dripped from the vehicle.
REPLENISHMENT OF COOLANT
Always keep radiator cap tightly closed.
1. Support vehicle on a level ground in a straight up position.
2. Open the battery cabinet door.
3. Open surge tank cap, refill coolant until reaches the upper mark.
• If coolant level becomes too low and occurs too often, it
may indicate there is something wrong with the coolant
system.
• To avoid radiator getting rusty, do not use coolants other than those recommended.
Coolant recommended: SYM Bramax radiator agent Concentration: 50%
CAUTION:
 Use soft water when mixing coolants.
 Please pay attention to using poor quality coolant may shorten the service life of the radiator.
 Coolant should be changed once a year normally.
 Add coolant to reserved tank.
 Cooling system maintenance can work on the vehicle.
 Do not coolant coating body cover surface
 After the maintenance of the system, confirm the cooling system has no leakage.
 When the engine is warm, do not open the radiator tank cover, high temperature of the coolant will
cause burns, the maintenance of cooling system can be carried out before the engine cooled out.
 Please refer to table for the concentration and temperature of the coolant when the air temperature is
below zero.
31