Engine Oil Inspection And Change; Oil Change - Sym ME20BW-COC Série Manuel D'utilisation

§ENGINE OIL INSPECTION AND CHANGE §
 INSPECTION:
1. Use the main parking stand to support the
motorcycle on a level ground, remove the oil
cover after engine stopped for 3~5 minutes.
2. Check whether oil level is in between the upper
and lower marks through oil level window.
 Add oil to upper limit if oil is under the lower limit.
(Check cylinder, crankcase...etc for leakage.

OIL CHANGE:

 Change period: First 1000km for new motorcycle,
and the engine oil has been just renewed every
3000km thereafter.
 Service more frequently when riding in dusty or cold
area.
 In order to maintain the engine's maximum
performance, check whether the engine oil is
enough every 500km. Add oil to upper limit if the
engine oil has been found to be inadequate.
 Engine Oil : Use (API) SH/CD SAE 10W-30 grade
or better engine oil. Otherwise, damage will not be
covered by warranty.
 Oil Capacity : 1.2 Liter (1 liters for routine change), oil
filter change: 1 liters.
 Use SAE 5W-40 when outside temperature is below 0
℃
【Oil Filter Cleaning】
The oil filter in engine left side, near change pedal.
Open the filter nut assembly of the filter, and remove the
filter. Remove the foreign materials from the filter by
using a gasoline or air spraying gun.
WARNING:
Oil level will not be correct when checking the oil

level with the motorcycle parked on an unleveled
ground or immediately after the engine stopped.
Engine and exhaust pipe are hot right after engine

stopped. Pay special attention not to get burned
when checking or replacing engine oil.
If the oil lever approach lower limit again after

refilled, check the engine for leaks and refill it
again.
Keep away from spark and flames when refilling

the oil.
Screw in the drain bolt and the oil gauge tightly

after refilled.
Oil cover
19
Oil in
Upper limit
Lower limit
Drain bolt
Oil filter
Filter nut