Tire Inspection; Steering Handle Front Shock Absorbers Inspection - Sym ME20BW-COC Série Manuel D'utilisation

§TIRE INSPECTION §
 Tires should be checked and inflated with the engine shut off.
 If a tire's ground contacting curve is abnormal, check it with an air pressure gauge and inflate it
to the specified pressure.
 Tires pressure must be checked with an air pressure gauge when cold.
PLEASE REFER TO SPECIFICATIONS FOR STANDARD TIRE PRESSURE
Foreign materials
(nails or small
stones)
CAUTION:
 Abnormal tire pressure, wear, or crack is the most important cause that results in the loss
control of the steering handle and a punctured tire(s).
§STEERING HANDLE FRONT SHOCK
ABSORBERS INSPECTION §
Perform this check with engine shut off and ignition

switch key removed.
Visual check front shock absorbers for damage.

Operate steering handle up and down, and check front

shock absorbers for noises due to bends.
Check the bolts and nuts of front shock absorbers with

wrenches for tightness.
Shake steering handle up & down, left & right, and front

& rear to check if it is loosen, has too much resistance
and pulls to one side.
Check steering handle if it is being pulled too tight by

the brake cables.
Take your motorcycle to Authorized Dealer or

Franchised Dealer for a check or adjustment if any
abnormal conditions are found.
 Visual check tires for frontal and lateral side walls
Crack and
for crack or damage.
damage
 Visual check tires for any nails or small stones
wedged in the tread.
 Check the "tread wear indicator" condition to see if
tread groove depth is insufficient.
 A tire with a wear bar showing is worn out and
should be replaced immediately.
Tread wear
indicator
23