Riding The Motorcycle; Set Up Riding - Sym ME20BW-COC Série Manuel D'utilisation

7. RIDING THE MOTORCYCLE

§SET UP RIDING §
 Check the brakes and tire pressure before riding.
 Ride the motorcycle from left side, put the foot on the
ground to prevent it from falling over.
 Start and warm up the engine.
1.
Squeeze the clutch lever fully, then push shift pedal
down to engage the 1st gear.
2.
Then release the clutch lever slowly, and at the
same time, open the throttle gradually, the
motorcycle will move.
CAUTION:
 After the engine was started and before
riding, don't operate the throttle grip rapidly to
rise up the engine speed.
 Change the gear position according to the driving
speed.
 The relationship between speed and gear
position is on the right table.
 Change the gear position according with the
table can get the good performance and fuel
economy of the motorcycle.
CAUTION:
 Do not operate the transmission when the
engine is not running.
 Do not push the shift pedal rudely to
prevent the transmission from be
damaged.
 Control the driving speed for passing other
vehicles.
CAUTION:
During the first 1000km, it is better to drive in low speed for running the engine in good condition and
long life.
 Change the engine oil and clean the oil filter screen after first 1000km.
 It is better to drive in low speed after have just replaced the engine oil.
 Warm up the engine before start riding.
Speed
1 st gear
2 gear
nd
3 rd gear
4 th gear
5 gear
th
14
20 40 60 80 100 120 140