Beginning Of The Spraying Process; End Of The Spraying Process - WAGNER PLASTCOAT 1030 Mode D'emploi

Plast Coat 1030
6.8

BEGINNING OF THE SPRAYING PROCESS

• Open the air flow regulator (fig. 13, 3) and the material tap
(13, 1) at the spray lance.
• Adjust the flow of material with the delivery volume con-
troller (fig. 13, 2) on the control unit and set the air quantity
by adjusting the air flow regulator (fig. 13, 3) to attain the
desired spray pattern.
Important: Do not let the mortar spraying
machine run dry. Switch the device off im-
mediately if no more material comes out of
the tip or if the spray line becomes irregu-
lar. Possible reasons for the problem and
how to correct it can be found in the chap-
ter called „Eliminating faults".
Increased material tap wear. Do not use the
material tap to set the material volume.
The delivery volume controller should be
used for this purpose.
6.9

END OF THE SPRAYING PROCESS

• Close the material tap (Fig. 13, 1).
• Close the air flow regulator (fig. 13, 3).
Always close material tap at end of the
spray process.
1
3
POWER ERROR
2
GB
COMMISSIONING
SPEED
41