Shaft Seal (Fig. 16); Rotor Replacement - WAGNER PLASTCOAT 1030 Mode D'emploi

Plast Coat 1030
9.4

SHAFT SEAL (FIG. 16)

Check the seals on the PC 1030 every month.
• Move selector switch (fig. 16, 1) to "A" and set delivery vol-
ume controller (2) to „0".
• Disconnect mains plug.
• Loosen the star screws (3) and remove the outlet unit (4).
• Set delivery volume controller (2) to 1 or 2.
• Connect mains plug to mains power supply.
• Move the selector switch (1) to position „F". As soon as the
stator (5) is released from the rotor (6), set the selector
switch to „A".
• Remove the stator (5) completely.
• Disconnect mains plug.
• Pull out the two locking pins (7) and remove the anti-twist
lock (8).
• Remove the flange (9) with a 17-wrench.
• Remove the container (10).
• Check the seal (11) and replace if necessary.
• Clean the shaft seal (12).
• Check the rotor (6) and replace if necessary (see chapter
9.5).
9.5
ROTOR REPLACEMENT (FIG. 17)
• Loosen fixing screw (1) and remove old rotor (6).
• Fit new rotor with new fixing screw.
• Glue fixing screw with Loctite 243.
Note: use Loctite 243 only.
8
7 6
12
1
GB
POWER ERROR
SPEED
1 2
5
4
3
3
10
8
11 9
6
45