Compressor (Accessory); Spray Attachment Assembly (Accessories); Connecting The Spray Lance (Fig. 10) - WAGNER PLASTCOAT 1030 Mode D'emploi

Plast Coat 1030
6.4

COMPRESSOR (ACCESSORY)

Place the compressor at a secure location next to the mortar
spraying machine and connect it to the mains network.
Note:
Only operate the compressor in accordance with the enclosed
operating manual.
6.5

SPRAY ATTACHMENT ASSEMBLY (ACCESSORIES)

Different accessories can be mounted to the
spray lance, depending on the application,
e.g. an extension can be attached. A precise
overview can be found in the "Accessories"
chapter.
• Disengage the quick connector and pull the air hose (fig. 8,
1) out of the lance.
• Loosen the locknut (2) and remove the material hose (3).
• Insert the material hose and air hose (if available), which
are part of the accessory, into the spray lance and secure
by tightening the locknut. (Fig. 9)
Attention: Make sure the O-ring (fig. 9, 4) is not dam-
aged.
6.6

CONNECTING THE SPRAY LANCE (FIG. 10)

• Select a spray tip suitable for the material:
The tip size should amount to at least three times the
granular size, e.g.
granular size artificial resin plasters –> 3 mm
Tip size –> 10 mm
• Mount the texture tip (1) in the spray lance with the cone
pointing towards the spray head.
• Connect the spray lance (2) to the material hose and secure
by applying the levers (3).
• Close the material tap (4) (material tap points forwards).
• Connect atomization air connection (5) to the air hose of the
mortar hose.
• Screw coupling plug (6) for remote control to the control ca-
ble of the mortar hose.
• Connect mortar hose's control cable to pump connection.
(Fig. 11)
• Set selector switch to "A".
4
3
5
6
COMMISSIONING
2
3
1
2 4
ELEC
PNEUM REMOTE
Controler Control
GB
1
39