Preparing The Mortar Spraying Machine (Fig. 12); Rinse The Mortar Hose - WAGNER PLASTCOAT 1030 Mode D'emploi

GB
COMMISSIONING
6.7
PREPARING THE MORTAR SPRAYING MACHINE
(FIG. 12)
Recommended sliding means for the mortar hose
Water is not sufficient as a sliding means.
Danger of clogging!
Use cellulose paste (e.g. Metylan wallpaper
paste, art no. 2312136)
• Fill 2–3 l cellulose paste into the container.
• Connect the mortar spraying machine to the mains supply.
The operation light (1) shows operational readiness.
Risk of injury from escaping material.
Before switching on, always check that the
material tap on the spray lance is closed
(material tap points forwards).
Close material tap whenever stopping
work.
• Set selector switch (2) to "A".
• Set delivery volume controller (3) to „3".
6.7.1

RINSE THE MORTAR HOSE

• Close the air flow regulator (fig. 13.2).
Do not bend the mortar hose!
Protect it against damage, for exam-
ple against being driven over as well as
against sharp objects and edges.
• Hold spray lance over an empty bucket.
• Open material tap (Fig. 13, 1) on spray lance (material tap at
90° to spray lance), the mortar spraying machine is switched
on.
• If cellulose paste comes out of the tip, close the material tap
(fig. 13, 1) (material tap points forwards).
• Fill coating material into the receptacle.
With mineral coating materials only fill the re-
ceptacle to half full.
• Position the spray lance over the bucket again.
• Replace container and lubricant with container and coating
material.
• Hold spray lance above container with cellulose paste.
• Open material tap (Fig. 13, 1) on spray lance.
• As soon as coating material exits from spray lance,
close material tap (Fig. 13, 1).
The mortar spraying machine is now full and ready.
40
1 2 3
1
3
POWER ERROR
2
Plast Coat 1030
SPEED