Parts / Controls Identification; Area Of Application; Transportation - WAGNER PowrDriver Mode D'emploi

Parts / Control Identification
10
18
12
13
14
15
2
3
1. Operator seat
2. Engine
3. Pneumatic tire and wheel
4. Ball hitch assembly
5. Adjustable seat rail
6. Dump valve*
7. Step position
8. Direction / speed pedals
9. Foot rest
10. Protection bar
11. Fuel access seat pin
12. Fuel valve
13. Choke lever
14. Gas lever
15. Gas tank
16. Oil tank (motor oil)
17. Oil tank (transmission oil)
18. Air filter
19. Adjustment lever for gas pedal
20. Trailer hitch for attachment to the LineCoat equipment (not
shown)
* The dump valve is used to relieve hydraulic pressure and
allows free-wheel movement of the PowrDriver's wheels when
it is shut off.
1
8
19
GB
6
16
9
7
4

Area of Application

The PowrDriver is only intended for use with the following Wagner
LineCoat equipment:
LC 820, LC 840, LC 860
The PowrDriver may only be used for marking jobs.

Transportation

The PowrDriver may not be hooked up to the trailer
hitch on a motor vehicle for transportation. PowrDriver
may solely be transported on a flat-bed trailer or other
transportation vehicle (i.e. a pickup truck) after it has
been securely fastened.
Danger of crushing! Several persons are needed to on
or off load PowrDriver.
PowrDriver may not be transported with a crane.
i
In order to be able to move the equipment with the
motor switched off, you must keep the by-pass valve
pressed down.
10
5
11
17
PowrDriver