WAGNER PLASTCOAT 1030 Mode D'emploi page 30

GB
TABLE OF CONTENTS
Table of Contents
1 SAFETY REGULATIONS ______________________ 31
2 INTRODUCTION TO WORKING WITH THE
MORTAR SPRAYING MACHINE PLASTCOAT 1030 33
2.1 Function of the mortar spraying machine
PlastCoat 1030 _______________________________ 33
2.2 Processible coating materials ___________________ 33
3 TECHNICAL DATA ___________________________ 33
4 EXPLANATORY DIAGRAM FOR PLASTCOAT 1030 34
4.1 Operating elements and displays on device _______ 35
4.2 Drive _______________________________________ 35
4.3 Compressor (accessory) _______________________ 36
4.4 Mortar hose _________________________________ 36
4.5 Spray lance _________________________________ 36
5 TRANSPORTATION __________________________ 37
5.1 Moving _____________________________________ 37
5.2 Transport using a crane (fig. 4) __________________ 37
5.3 Transportation in vehicle ______________________ 37
6 COMMISSIONING ___________________________ 37
6.1 Installation location ___________________________ 37
6.1.1 Connection to mains power supply/ Extension cable 37
6.2 Initial starting-up _____________________________ 37
6.2.1 Scope of supply ______________________________ 37
6.2.2 Assembly (fig. 5) _____________________________ 38
6.3 Connecting the mortar hose ___________________ 38
6.4 Compressor (accessory) _______________________ 39
6.5 Spray attachment assembly (accessories) _________ 39
6.6 Connecting the spray lance (fig. 10) ______________ 39
6.7 Preparing the mortar spraying machine (fig. 12) ____ 40
6.7.1 Rinse the mortar hose ________________________ 40
6.8 Beginning of the spraying process _______________ 41
6.9 End of the spraying process ____________________ 41
7 GENERAL INFORMATION ABOUT THE
APPLICATION TECHNIQUE ___________________ 42
7.1 Spraying technique ___________________________ 42
8 SHUTTING DOWN AND CLEANING ____________ 42
8.1 Cleaning the mortar hose ______________________ 42
8.2 Cleaning the device and replacing the stator ______ 42
8.3 Cleaning the spray lance _______________________ 44
30
9 MAINTENANCE _____________________________ 44
9.1 Mechanical maintenance ______________________ 44
9.2 Electrical maintenance ________________________ 44
9.3 Long periods of non-usage _____________________ 44
9.4 Shaft seal (fig. 16) ____________________________ 45
9.5 Rotor replacement ___________________________ 45
10 ELIMINATING FAULTS ________________________ 46
11 SPARE PARTS LIST FOR PLASTCOAT 1030 ______ 50
11.1 Spare parts list frame _________________________ 50
12 SPARE PARTS LIST OF SPRAY LANCE __________ 50
13 PLASTCOAT 1030 ACCESSORIES ______________ 52
Testing of the mortar spraying machine _______________ 54
Note on disposal __________________________________ 54
Important information on product liability_____________ 54
Guarantee declaration _____________________________ 54
CE declaration of conformity ________________________ 55
European service network _________________________ 112
Plast Coat 1030