Transportation; Moving; Transport Using A Crane (Fig. 4); Transportation In Vehicle - WAGNER PLASTCOAT 1030 Mode D'emploi

Plast Coat 1030
5

TRANSPORTATION

5.1

MOVING

Wind power cable around handle and remove the hose.
Put away the nozzles and other small objects in the storage
compartment.
Push or pull the PC 1030 by the handle.
Make sure that 2 people are available to
carry the device on stairs.
5.2

TRANSPORT USING A CRANE (FIG. 4)

For attaching points for the straps or rope (not wire cable) see
figure.
5.3

TRANSPORTATION IN VEHICLE

Secure the unit in the vehicle by means of suitable fasteners.
To avoid material residues leaking from the
machine, clean the device in advance or lock
the mortar connection.
6

COMMISSIONING

6.1

INSTALLATION LOCATION

Position mortar spraying machine in a level position to pre-
vent it from sliding away.
6.1.1
CONNECTION TO MAINS POWER SUPPLY/
EXTENSION CABLE
Connection to the mains network only via a special feed-
ing point, for example via a distribution board for con-
struction sites, with residual current protective device
with INF 30 mA.
Lay the device supply cable so that there is no
danger of stumbling.
Protect against damage, for example against
being driven over.
Min. wire cross-section 3 x 2.5 mm
extension cable completely. Ensure that the
coupling pieces and plugs are free of damage.
• Before connecting the unit to the mains supply, ensure that
the line voltage matches that specified on the rating plate.
6.2

INITIAL STARTING-UP

6.2.1

SCOPE OF SUPPLY

The machine is supplied by the manufacturer in the following
individual components:
• Complete basic machine comprising drive unit, control unit,
receptacle and transport frame with wheels
• Stator
• Hose package
• Spray lance
• Pump sliding means
• Tool box with nozzles, cleaning accessories,...
GB
TRANSPORTATION
2
. Unroll the
37