Display Settings - Fronius Symo 10.0-3 208-240 Instructions De Service

Date display format
For setting the format in which the date is displayed
Setting range
Factory setting
Daylight saving time
Activate / deactivate automatic daylight saving time adjustment
Setting range
Factory setting
IMPORTANT! The time and date must be correct to ensure that the daily and yearly values
and the daily characteristics are displayed correctly.

Display Settings

Setting range
Language
Setting the display language
Setting range
Night Mode
DATCOM night mode; controls DATCOM and display operation at night or when there is
insufficient DC voltage available
Setting range
Factory setting
Contrast
set contrast on the display
mm/dd/yyyy / dd.mm.yy
Depends on the country setup
NOTE! Only use the function for automatic daylight saving time adjustment when
there are no LAN or WLAN-compatible system components in a Fronius Solar Net
ring (e.g., Fronius Datalogger Web, Fronius Datamanager).
If LAN or WLAN-compatible system components are found, adjust this setting on
the system component web interface.
on / off
on
Language / Night mode / Contrast / Illumination
German, English, French, Dutch, Italian, Spanish, Czech, Slo-
vak, etc.
AUTO / ON / OFF
OFF
AUTO: DATCOM operation is constant as long as a Datalogger is connected to an
active, uninterrupted Solar Net.
The display is dark during the night and can be activated by pressing any
key.
ON: DATCOM operation is constant. The inverter provides 12 V constantly to
supply Solar Net with power. The display is always active.
IMPORTANT! The power consumption of the inverter is increased at night
to approximately 7 W when the DATCOM night mode is ON or on AUTO and
Solar Net components are connected.
OFF: No DATCOM operation at night, the inverter requires no AC power to supply
Solar Net.
The display is deactivated at night; the Fronius Datamanager is not avail-
able.
35