Display Settings - Fronius Primo 3.0-1 Instructions De Service

Summer/winter time
Activate/deactivate automatic changeover between summer and winter time
IMPORTANT! Only use the automatic summer/winter time changeover function if the
Fronius Solar Net ring does not include any LAN- or WLAN-compatible system compo-
nents (e.g. Fronius Datalogger Web, Fronius Datamanager or Fronius Hybridmanager).
Setting range
Factory setting
IMPORTANT! The time and date must be set accurately in order for the day and year val-
ues and for the day characteristic to be displayed correctly.

Display settings

Setting range
Language
Set language for display
Setting range
Night mode
DATCOM night mode; controls DATCOM and display operation during the night or when
the DC voltage is insufficient
Setting range
Factory setting
Contrast
Set the contrast on the display
Setting range
Factory setting
Since the contrast is temperature-dependent, it may be necessary to adjust the setting
under the "Contrast" menu item when the environmental conditions change.
on / off
on
Language / Night mode / Contrast / Illumination
German, English, French, Dutch, Italian, Spanish, Czech, Slo-
vak, etc.
AUTO / ON / OFF
OFF
AUTO: DATCOM mode is always in effect as long as there is a Datalogger connect-
ed in an active and uninterrupted Fronius Solar Net.
The display remains dark during the night, but can be activated by pressing
any key.
ON: DATCOM mode is always in effect. The inverter supplies 12 V continuously
to power the Fronius Solar Net. The display is always active.
IMPORTANT! If DATCOM night mode is set to ON or AUTO when there are
Fronius Solar Net components connected, then the inverter's current con-
sumption during the night will increase to around 7 W.
OFF: DATCOM will not run at night, the inverter will not need any AC current in
order to supply power to the Fronius Solar Net.
The display is switched off during the night and the Fronius Datamanager is
not available.
0 - 10
5
33