Datcom; Usb - Fronius Symo 10.0-3 208-240 Instructions De Service

DATCOM

Check of a data communication, entry of the inverter number, DATCOM night mode, pro-
tocol settings
Setting range
Status
Displays data communication available via Solar Net or an error that occurred in data com-
munication
Inverter Number
Number setting (address) of the inverter in a setup where multiple solar inverters are linked
together
Setting range
Factory setting
IMPORTANT! Each inverter must be assigned its own address when using multiple invert-
ers in a data communications system.
Protocol type
Defines the communication protocol used to transmit data:
Setting range
Factory setting
* The protocol type Interface Protocol only works without the Datamanager card. Available
Datamanager cards must be removed from the inverter.

USB

Value settings when using a USB stick
Setting range
Disconnect HW Device
To remove a USB stick from the USB A socket on the data communication rack without
losing data.
The USB stick can be removed:
-
-
Software Update
For updating inverter software using a USB stick.
Procedure:
1
***
WiFi Access Point
[not available]
Is displayed, when no system monitoring is present at the invert-
er.
Status / Inverter number / Protocol type
00 – 99 (00 = 100 inverter)
01
Solar Net / Interface Protocol *
Solar Net
Disconnect HW device/Software update/Logging interval
When OK is displayed
When the "Data Transfer" LED is no longer flashing or lit
Download the "froxxxxx.upd" update file
(e.g., at http://www.fronius.com; xxxxx stands for the version number in question)
31