Fronius Symo 10.0-3 208-240 Instructions De Service page 23

IMPORTANT! To establish a connection to Fronius Datamanager 2.0, the end device in
question (e.g., laptop, tablet) must be configured as follows:
- "Obtain an IP address automatically (DHCP)" must be activated
WARNING! An electric shock can be fatal. Danger from grid voltage and DC volt-
age from solar modules.
Before opening the inverter:
- You must wait until the capacitors have discharged.
- Follow the operating instructions when opening the inverter.
- Observe the safety rules and safety instructions contained in the inverter's
operating instructions.
Connect inverter with Fronius Datamanager 2.0 or Fronius Datamanager Box 2.0 in
1
Fronius Solar Net
Set the Fronius Solar Net master/slave switch on the Fronius Datamanager 2.0 plug-
2
in card correctly
- One inverter with Fronius Datamanager 2.0 = master
- All other inverters with Fronius Datamanager 2.0 = slave (the LEDs on the Fro-
nius Datamanager 2.0 plug-in cards are off)
Switch the device to service mode
3
- Switch the IP switch on the Fronius Datamanager 2.0 plug-in card to position A
or
- Activate the WIFI Access Point via the inverter Setup menu
(How this function is carried out depends on the inverter software.)
S t a n d b y
W i F i A c c e s s P o i n t
D A T C O M
U S B
C l o c k
The inverter establishes the WLAN Access Point. The WLAN Access Point stays open for
1 hour.
Connect the end device to the WLAN Access Point
4
SSID = FRONIUS_240.xxxxx (5–8 digits)
- Search for a network with the name "FRONIUS_240.xxxxx"
- Establish a connection to this network
- Enter password 12345678
(or connect end device and inverter via Ethernet cable)
Enter in the browser:
5
http://datamanager
or
21