Electrical Connections - Erreka LINCE Manuel De L'installateur

INSTALLATION
4

ELECTRICAL CONNECTIONS


Complete the installation in line with low voltage regulations and applicable rules.

Use cables with sufficient section, and always earthed.

Check the manufacturer's instructions for all the elements installed.

General connections
O
When installing batteries, ensure they are connected through an external charger
(CHG). Do not connect them directly to the control board.
The ADO01 kit is recommended, consisting of a charger and two 12V /1.2Ah batteries,
as it has been designed for use in this operator.
BAT
(2x12V/1,2 Ah)
ADO01
ADO01 Charger kit (CHG) + batteries (2x 12V / 1.2Ah)
BAT Batteries
SMF Signal light card AEPS1-001
SCA SCA light (24Vdc)
A.T Total opening operation device
A.P Pedestrian opening operation device
SG.C Closing safety device (mechanical strip or
photocell)
SG.A Opening safety device (mechanical strip or
photocell)
52
Installation Manual
CHG
ST1
ST2
COM
FT1
FT2
FT Output 24Vdc for photocells (terminals 6 and 7)
AUX Output 24Vdc (terminals 7 and 8)
DEST Flashing light (max. 60W)
LIS424 - LIS624: 230Vac;
LIS424M - LIS624M: 125Vac
LG Garage light (max. 2,300W resistive)
LIS424 - LIS624: 230Vac;
LIS424M - LIS624M: 125Vac
ANT Antenna connection
R.E Plug-in receiver