Erreka LINCE Manuel De L'installateur page 55

Remove the motor covers
1 Loosen the screws (2) without releasing them
and lift off the upper cover (1).
2 Remove the terminal cover (3).
3 Lift off the screw covers (4).
Position the rack and secure the actuator
Position the actuator
1 Position the actuator on the base plate and
secure it with the supplied screws (1) and
washers (2).

Do not tighten the screws.
2 Level the actuator using the four threaded
studs (3).
1 Position the rack (1) on the gate and secure it
provisionally.

Check the rack instructions.
2 Unlock the actuator using the handle (2).
3 Manually move the gate throughout the travel to
check that the pinion (3) moves correctly on the
rack.
O
There should be a slight gap (approximately 1-2
mm) between the teeth of the pinion and the rack.
4 Definitively secure the rack. If necessary, adjust the
height of the actuator with the threaded studs (4).
5 Secure the actuator by turning the screws (5).
INSTALLATION
LINCE actuator for sliding gates
51