Actuator Installation - Erreka LINCE Manuel De L'installateur

INSTALLATION
3

ACTUATOR INSTALLATION


Procedure
Secure the base plate to the floor
AB
50
Installation Manual
Assembly positions and levels
1 Gate
2 Rack
3 Base plate
O
(a > b)
4 Drive pinion
5 Ducts for electrical installation
1 Position the ducts (1) for electrical installation.
2 Secure the base plate to the floor, taking into
account the assembly levels.
O

of the two methods described below:
A- Using screws or lag screws
• Introduce the screws or lag screws (2) through
B- Using the tabs
• Fold the tabs (4) of the plate at the height of the
• Fold the base (5) of the tab (fold each part in one
• Introduce the tabs on the base plate, which is still
BEWARE: the base plate is not symmetric
BEWARE: the base plate is not symmetric (a > b)
In order to secure the plate to the floor, use one
the grooves (3) of the plate.
groove (3).
direction in order to ensure attachment to the
base plate).
wet, until the edge of the base plate is supported
on the floor.