Checking The Impact Force; Final Checks - Erreka LINCE Manuel De L'installateur

START UP AND PROGRAMMING
4

CHECKING THE IMPACT FORCE

F < 400N in spaces between 50mm and 500mm
d
F < 1400N in spaces> 500mm
d
5

FINAL CHECKS

Following installation and programming, start up the
actuator and check the devices installed.
1 Check the correct operation of the control devices
(button and wall key, remote control).

See "Operation modes" on page 46.
2 Check the correct operation of the safety devices
(photocells or mechanical strips).

See "A- Detection by photocell or safety strip"
on page 46.
3 Place an obstacle and make the gate collide with it
in order to check operation in the event of collision.

See "B- Direct detection (built-in safety)" on
page 46.

If the system does not work correctly, find out
why and put it right (see section "Failure
diagnosis" on page 60).
58
Installation Manual
1 Measure the impact force and compare it to the
values indicated in Standard EN12453:2000. If the
values measured are higher than those in the
Standard, reduce the maximum force, the speed of
the gate, the soft stop speed, or increase the soft
stop distance.

Gate speed: A20X

Soft stop speed: A30X

Soft stop function: A40X

Maximum force: A6XX

The control panel must be programmed in a
manner which respects the values indicated in
standard EN 12453:2000, as shown in the
attached chart. The measurements must be
made in line with the method described in
standard EN 12445:2000.
• The standard indicates that at distances of
between 50mm and 500mm, the dynamic
force must be less than 400N. At distances of
over 500mm, the dynamic force must be less
than 1400N.
User instruction
1 Instruct the user with regards to the use and
maintenance of the installation and provide him/her
with the instructions on use.
2 Signal the gate, showing that it opens automatically
and indicating how to operate it manually. Where
appropriate, indicate that operation is using the
remote control.