Electrical Connections - Erreka TORO Manuel De L'installateur

4

ELECTRICAL CONNECTIONS

 Complete the installation in line with low voltage regulations and applicable rules.

Use cables with sufficient section, always earthed.

Check the manufacturer's instructions for all the elements installed.
General connections KM1800
R.E
Plug-in receiver
ANT
Cable connectors for antenna
SMF
Traffic light card AEPS1-001
FCC
Magnetic closing limit switch (Hall effect
sensor) (supplied installed and connected in
the lower plate; the one in the upper plate is
not operative)
FCA
Magnetic opening limit switch (Hall effect
sensor) (supplied installed and connected in
the lower plate; the one in the upper plate is
not operative)
A.T
Total opening key command
A.P
Pedestrian opening key command
Fig. 4 KM1800 operator connections
(photocells with testing)
SG.C
Closing safety device (mechanical strip or
photocell)
SG.A
Opening safety device (mechanical strip or
photocell)
AUX
Output (24Vdc, 300mA)
Constant output in order to feed peripheral
devices (photocells without testing)
FT
24Vdc output for photocell testing
STOP
Emergency pushbutton
LG
Garage light (230Vac, max. 2,300W resistive)
DEST
Flashing light (230Vac, max. 60W)
E1
Without use
INSTALLATION
(photocells without testing)
TORO operator for sliding gates
65