Installation; Tools And Materials; Initial Conditions And Checks - Erreka LINCE Manuel De L'installateur

INSTALLATION

1

TOOLS AND MATERIALS

Set of screwdrivers
Spanner 17mm
Allen key 4mm
Marker pencil
2

INITIAL CONDITIONS AND CHECKS

Initial conditions of the gate

Check that the size of the gate is within the
admissible range of the actuator (see the
technical characteristics of the actuator).

If the gate to be automated has a passage gate,
use a safety device to prevent the actuator
from operating with the passage gate open.

The gate must have a closing stopper and an
opening stopper.
Environmental conditions

This device is not suitable for installation in
inflammable or explosive environments.
Electrical power supply installation

Ensure the power supply installation fulfils the
following requirements:
• The nominal voltage of the installation must
coincide with that of the control panel.
• The installation must be able to support the
power consumed by all the automatic
operation devices.
• The installation must be earthed.
Level
Tape measure
Underground electrical cable ducts

The gate must be easy to manipulate manually,
namely:
• It must be balanced, in order to ensure the effort
made by the motor is minimum.
• There should be no stiffness throughout its travel.

Do not install the actuator in a gate which does
not work correctly in manual operation, as this
may lead to accidents. Repair the gate before
installing.

Check that the admissible environmental
temperature range for the actuator is suitable
for the location.
• The electrical installation must comply with
low voltage regulations.
• The installation elements must be properly
secured and in a good state of conservation.

If the electrical installation does not comply
with the foregoing requirements, repair before
installing the automatic operation device.
English
LINCE actuator for sliding gates
49