Nilfisk RS 2200 Manuel D'utilisation page 133

• Consultation of B_BOX
alarms occurred after the last memory reset are stored.
The alarm is identifi ed by a number code that can be
displayed as shown below: repeatedly press the upper
part of the push-button (23, Fig. E) until "MAIN MENU"
appears. Confi rm by pressing the lower part of the
push-button (23, Fig. E). The arrow cursor (1, Fig. J)
will be placed near the word "STATUS". Press the lower
part of the push-button (23, Fig. E) again to bring the
arrow cursor near the word "MAINTENANCE". Confi rm
by pressing the upper part of the push-button (23, Fig.
E). On the display (32, Fig. E) the page "MAINT.01"
is shown; when pressing the upper part of the push-
button (23, Fig. E) again, the page "MAINT.02" is
shown. When pressing the lower part of the push-
button (23, Fig. E), the cursor aligns with B_BOX,
then enter the B_BOX by pressing the upper part of
the push-button (23). In this page, the fi rst series of
numbers (33, Fig. J) indicates the alarm identifi cation
number, while the second series of numbers (34)
indicates the time at which the alarm occurred. The
stored alarms are up to 16 displayed on four pages,
which can be scrolled by pressing the push-button
(23, Fig. E) repeatedly. The alarms shown are both
instrument inner alarms and CAN-BUS transmission
line inner alarms indifferently.
CAUTION!
In the B_BOX the alarms are stored one
after the other, so when the alarms are
detected, always check for the time at
which the alarm occurred to have a real
chronology of the alarms.
(7, Fig. J), where all the
RS 2200
USER MANUAL
Machine layout description
(See Fig. F)
1. Fuel tank
2. Right front water tank
3. Right rear water tank
4. Steering cylinder
5. Right rear drive wheel
6. Right front wheel
7. Hopper
8. Right side water tank drain plug
9. Fuel tank fi ller cap
10. Engine air fi lter
11. Drive system pump
12. Turbine pump
13. Accessory pump
14. Battery hygrometer
15. Condenser electric fan
16. Right front water tank lower fastener
17. Right front water tank upper fastener
18. Battery
19. Hydraulic system oil tank drain plug
20. Hand pump lever
21. Compressor
22. Coolant drain hose
23. Dust control system pump fi lter
24. Climate control system condenser
25. Frame number
26. Suction inlet-hopper branch pipe
27. Suction fan assembly
28. Hand pump
29. Radiator fan motor
30. DPF differential Pressure Sensor
31. Vacuum modulators
33019476(3)2010-02 A
ENGLISH
11