Maintenance; Scheduled Maintenance Table - Nilfisk RS 2200 Manuel D'utilisation

ENGLISH

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defi ned by the person in charge of the maintenance.
WARNING!
To perform maintenance procedures turn off the machine (remove the ignition key) and turn the battery release
switch (37, Fig. G) to OFF (see Fig. X).
Moreover, read carefully the instructions in Safety chapter before performing any maintenance procedure.
WARNING!
When performing maintenance procedures which require hopper lifting, the support rod (1, Fig. M) must be
engaged. See the procedure in Hopper Support Rod Installation paragraph.
CAUTION!
Do not perform maintenance procedures when the machine lifting device is activated (leaf springs at the end of
stroke).
NOTE
When performing maintenance procedures, use only original spare parts.
NOTE
The display (32, Fig. E) is programmed to show an expired or nearly expired maintenance by means of the symbol
Maintenance must be performed at 150 and 500 hours (see Display Functions paragraph).
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an authorised Service
Center.
This Manual contains the Scheduled Maintenance Table and describes only the easiest and most common maintenance
procedures.
For other maintenance procedures contained in the Scheduled Maintenance Table or for extraordinary maintenance procedures see
the Service Manual that can be consulted at any Service Center.

SCHEDULED MAINTENANCE TABLE

Maintenance
Engine oil level check
Brake fl uid level check
Hydraulic system oil level check
Engine coolant level check
Engine air fi lter cleaning
Air fi lter cyclone block cleaning
Particulate fi lter cleaning
Particulate fi lter regeneration
Engine air fi lter replacement
Combined radiator fi n check
Combined radiator fi n cleaning
Coolant line check
Engine cylinder head tightening
34
USER MANUAL
After
Long
every
periods
use
33019476(3)2010-02 A
Every Every Every
40 150 200
hours hours hours
(6)(7)
(2)
RS 2200
Every Every Every
300 500 800
hours hours hours
(9)
.
Every Every
1,000 1,500
hours hours