Control Panel Functions - LERICA C254 Mode D'emploi

Rev. 03 - 07/2015 - Cod. 1501151 - Instruction manual for vacuum chamber packaging machines Mod. C254-C308-C312-C412-C420
8.1.6 CONTROL PaNEL FUNCTIONS
POS. COmPONENt
Key to activate jar
1
functions (PUMP)
vacuum/Gas key
2
(vaC/GaS)
Cursor key
3
(UP und dOWN)
4
Seal key (SEaL)
5
STOP Key
6
LEds
7
display
8
vacuum gauge
9
Main switch
10
1
7
6
FUNCtION
• Starts the vacuum cycle in containers.
• Regulates the vacuum functions, additional vacuum and gas
• When pressed for 4 seconds, it activates the sensor calibration function.
• Scroll through the programs.
• Change the values of the functions.
• Pressed together for 4 seconds, they allow to reset stored programs and re-
stores the factory settings.
• Regulates the sealing duration.
• When pressed during the work cycle, it starts the sealing in advance.
• Activates sealing in the packaging of external channelled bags.
• Interrupts the cycle in progress
• If pressed for 4 seconds, it allows to display the number of cycles performed.
• When pressed during start-up, it activates or deactivates the audible signal.
• They display the current cycle.
• It displays the active program.
• It displays the active function and the relative value set.
• It displays alarm warnings.
• It displays the number of cycles performed before the oil must be replaced.
• Indicates the vacuum in the chamber.
• Switches the machine "ON/OFF"
• Emergency stop.
2 8
5 4
9
3
10
93