Operation Using Embossed External Bags - LERICA C254 Mode D'emploi

Rev. 03 - 07/2015 - Cod. 1501151 - Instruction manual for vacuum chamber packaging machines Mod. C254-C308-C312-C412-C420
8.4 OPERaTION USING EMbOSSEd EXTERNaL baGS
WaRNINGS!
• Special vacuum bags made of Pa/PE must be used for this operation. These are called "enti-
rely embossed", and are distributed by Friulmed S.r.l. Request them from the dealer in your
area or directly from Friulmed S.r.l.
• attention: not all embossed bags available on the market are suitable for this purpose.
• The product to be packed must be dry and cold for the maximum vacuum to be reached (read Chap. 6
carefully). always dry the vacuum chamber and the plastic panels thoroughly.
• at first start-up make sure you have performed the calibration of the vacuum sensor (see Chap. 7 - pt.
1: press the vaC/GaS key for 4 seconds with the machine on. Lower the lid to start the calibration
and wait until the cycle ends).
• When work is complete, detach the piston by pushing it toward the rear and lower the lid to the resting
position. This protects the vacuum chamber from dust and dirt.
1) Open the lid. Lift the lid all the way and attach the piston, moving it forward (Fig. 1-2-3).
2) adjust the number of panels. Position the maximum number of panels
with respect to the dimensions of the product to be packed.
Fig. 1
100
Fig. 2
Fig. 3
a
that the chamber can take
a