Maintenance And Technical Support; References To The User Manual; Basic Safety Standards For Machine Maintenance And Technical Support - LERICA C254 Mode D'emploi

Rev. 03 - 07/2015 - Cod. 1501151 - Instruction manual for vacuum chamber packaging machines Mod. C254-C308-C312-C412-C420
10. MaINTENaNCE aNd TEChNICaL SUPPORT
10.1 REFERENCES TO ThE USER MaNUaL
see USER section 9.
10.2 baSIC SaFETy STaNdaRdS FOR MaChINE MaINTENaNCE aNd TEChNICaL
SUPPORt
Maintenance and/or repairs must be carried out in accordance with the following rules:
ELECTRICaL hazaRd!
• The power sources must be disconnected before performing maintenance and/or repairing
any component of the appliance (disconnect the electrical plug from the mains).
daNGER!
• It is prohibited to remove the guards and safety devices in order to carry out maintenance
operations. Friulmed S.r.l. declines all liability for accidents due to non-compliance with the
above-mentioned obligation.
aTTENTION!
• always use suitable preventive measures and protective clothing (gloves, etc.) for any maintenance
and/or repairs.
• Only qualified technicians must perform maintenance or access live parts of the machine as specified
in this chapter.
• Only original spare parts must be used and requested: spare parts that are not type-approved could
damage the appliance or cause physical injury.
• always cite the model and serial number of the machine (see section 1.4) in order for us to ensure
efficient support and to best answer your questions.
112
Symbols in the manual: see USER section 2.1.
handling and unpacking: see USER section 4.
Installation: see USER section 7.
Routine maintenance (cleaning) and scheduled periodic maintenance: