Updating The Software - LERICA C254 Mode D'emploi

Rev. 03 - 07/2015 - Cod. 1501151 - Instruction manual for vacuum chamber packaging machines Mod. C254-C308-C312-C412-C420
6) Pull out the gas spring (Fig. 7). Insert the new gas spring and screw it on the lower sliding pin
7) Re-attach the gas spring, inserting the pin and locking it in place with the elastic ring that was previously
removed (Fig. 8).
Fig. 7
Fig. 8
11.12 UPdaTING ThE SOFTWaRE
1) Load the firmware using the specific "Seraminet" program on your Bootleader (previously installed on your
PC or laptop).
2) Select the firmware to be loaded on the bootleader switch by lowering the relative lever.
124
d .
d