Product Description; Product Components - Fig; Scope Of Application - Fig - SOMFY WISNIOWSKI Metro 800 RTS Manuel D'installation

Metro 800 RTS / Metro 1000 RTS
* For zones 2, 3 and 4, no protection is required if the door
has continuous control or if the danger zone is more than
2.5 m above ground or any other permanent access level.
Deformable cover ensuring
a safety distance of 25 mm
in the compressed position
Figure 3 - Mechanical protection
Figure 4 - Safety distance
Copyright © 2016 Somfy SAS. All rights reserved

2 - PRODUCT DESCRIPTION

2.1 Product components - Fig. 1

Key Number Description
1 1 Motor head
2 1 Motor cover
3 1 Built-in light cover
4 1 Lintel bracket
5 1 Door bracket
6 2 Ceiling bracket
7 2 Motor head bracket
8 1 Manual release cord
9 1 Link arm
10 1 Travel stop
11 4 Chain retainer pad
12 1 Power cable
13 4 Hex. head M8x16 bolt
14 4 Hex. head M8x12 bolt & washer
15 6 HU8 nut
16 2 Shaft
17 2 Circlips
19 4 Self-shaping Ø 4x8 screw
20 2 Special screw for plastic Ø 3.5x12
21a 1 Single part rail
21b 1 Two part rail
21b1 1 Sleeve
21b2 8 Self-shaping Ø 4x8 screw
22 2 HM8 self-locking nut
23 2 Bracket
24 1 Spacer
25 2 Remote control*
26 1 24 V 21 W BA15s socket light bulb
* The model and number of remote controls may vary depending on the pack.

2.2 Scope of application - Fig. 2

This motorisation is exclusively intended for the equipement of a garage door
for residential use.
Types of doors (Fig.2)
The Metro motorisation is designed to motorise:
A: Projecting up and over door.
B: Sectional door:
- if the door's
mounting bracket" ref.: 9009390.
- if the door surface exceeds 10 sq. metres
adapter" ref.: 2400873.
C: Sideways opening sliding door:
- for side wall mounting, use:
- a belt transmission rail
-
- for ceiling mounting, use:
-
D: Swinging door. Use the swinging door kit, ref.: 2400459.
E : Semi and non projecting door. Use:
- a high performance transmission rail
-
Some doors of this type may prove impossible to automate. Contact
Wisniowski's technical department.
Door dimensions (Fig. 3)
For maximum door heights, the motor travel can be optimised:
- By installing the motor head at a 90° angle (Fig. 7-
-
200 mm (Fig. 5 - )
- By cutting the link arm to size.
Number of cycles per hour: 20 cycles/hour spread evenly throughout the
hour
EN
).
5