Product Description; Composition - Fig; Field Of Application - Fig; Installation - SOMFY HOME MOTION Dexxo Compact RTS Manuel D'installation

Dexxo Compact RTS

2 - PRODUCT DESCRIPTION

2.1 Composition - Fig. 1

No. Qty Description
1 1 Motor head
2 1 Flap
1 Lintel bracket
4 1 Door bracket
5 2 Ceiling mounting bracket
2 Motor head mounting bracket
7 1 Manual back release device
8 1 Connecting arm
1
10 4
11 1 Power supply cord
12 4
2
14
15 2 Shaft
2 Circlips
17 4
18a 1 Single unit rail
18b 1 2-part rail
18b1 1 Sleeve
18b2 8
2
20 1
21 2 Chain bearings
* The model and number of remote controls may vary depending on the pack.

2.2 Field of application - Fig. 2

This drive is exclusively intended to equip a garage door designed for indoor
residential use not exposed to inclement weather.
Types of door (Fig.2)
The DEXXO
A
B
-
Door dimensions (Fig. 2)
-
-
relation to the lintel (Fig. 4- )
- By cutting the connecting arm.

3 - INSTALLATION

manual release of the product.
3.1 Installation height - Fig. 3
-
-
between 10 and 200 mm.

3.2 installation steps - Fig. 4 to 14

Mounting the lintel yoke and door yoke (Fig. 4)
mm max in relation to the lintel. (Fig. 4-
Copyright © 2015 Somfy SAS. All rights reserved
(Fig. 6- ).
).
Assembling the 2-part rail (Fig. 5)
[1]. [2]. [3]. Unfold the 2 sections of the rail.
[4]. Assemble the 2 sections of the rail using the sleeve.
[5]. Secure the assembly using 8 mounting screws.
[6]. Tighten the nut to tension the chain or belt. The compressed rubber must
measure 18 and 20 mm.
screws.
Assembling the rail to the motor head (Fig. 6)
Mounting the assembly on the garage ceiling (Fig. 7 to 9)
Mounting the lintel yoke (Fig. 7)
Mounting to the ceiling
(Fig. 9 - ).
Mounting the arm to the door and carriage (Fig. 10)
[1].
[2]. Bring the carriage level with the door.
[3]. Secure the arm to the door yoke and carriage.
Adjusting and mounting the opening stop (Fig. 11)
[1].
door to the open position.
[2]. Position the stop against the carriage and secure it to the rail.
Mounting the chain bearings (Fig. 12)
For chain rails only.
past the outside of the rail.
Checking the tension of the chain or belt (Fig. 13)
tension.
Connection to the electrical power supply (Fig. 14)
[1]. Fit the light.
[2]. Connect to the mains supply.
waiting for auto-programming.
(Fig. 8).
(Fig. 9)
4