SICE S 65 E Manuel D'instructions page 96

Wheel data entry for wheel balancers with an ultrasonic sensor
To enter the distance, diameter and width values automatically, proceed as follows:
- bring the automatic internal measuring arm into contact with the inner side of the rim
(fig.15). Take great care to position the arm correctly so as to ensure accurate data
reading.
- Keep the arm in contact with the rim until the machine has acquired the wheel's diam-
eter and distance values. The following screen appears during this phase:
- if only one measurement is taken, the machine interprets the presence of a rim with
balancing using a clip weight (Dynamic Balancing Programme)
- when the automatic internal measurement arm returns to the rest position, the following
icons are automatically displayed on the screen:
- : pressing the ENTER key, the type of tyre is enabled - i.e. P TYRE
(Passenger Tyre) for average sized wheels (wheels in which the tyre shoulder protrudes
only slightly from the rim) or LT TYRE
off-road vehicles or lorries, or wheel in which the tyre shoulder protrudes notably from
the rim);
96
(if installed)
(Light Truck Tyre) for large wheels (for
Operator's Manual S 65 E - S 65 E C