SICE S 65 E Manuel D'instructions page 109

• mount the motorcycle shaft on the adapter
• mount the wheel after selecting the centring cones
(one for each side of the wheel), tighten with the
appropriate ring nut using the spacers necessary
for coupling the securing cones to the threaded
part of the shaft.
IMPORTANT: the wheel must be fixed to the
flange so as to avoid any movement of the two
during the spin or braking phases.
- Select the Balancing programmes
icon, then press ENTER to set the motorcycle
ambient.
- Fit the appropriate extension on the inner
measuring arm, specifically extension A on
machines with no weight holder or extension
B on machines with weight holder (Fig. 24 a).
- Set the wheel data as usual.
- Proceed as described for dynamic balancing.
Motorcycle ALU programme
Proceed as follows to balance motorcycle wheels
dynamically using adhesive weights:
- follow the instructions for mounting the motorcycle
adapter described in the MOTORCYCLE DYNAMIC
PROGRAM.
Proceed as described previously for the "Motor-
cycle Dynamic" programme.
Perform a spin.
- at the end of the spin, select the balancing pro-
gramme icon
required programme is selected.
- When applying the adhesive weight, always use the 12 o'clock position as your refer-
ence, regardless of the setting made in "Adhesive Weight Application Position".
Best results can be achieved if the adhesive weights are positioned with the outer
edge being flush with the rim edge.
Some rims have spokes so wide that it is not possible to place adhesive weights next to
them; a programme which divides the counterweights into two parts has been introduced
to solve this problem.
In this case, when the centred position is reached and it becomes obvious that the bal-
Operator's Manual S 65 E - S 65 E C
and press ENTER until the
Split Weight Programme
24
24a
109