SICE S 65 E Manuel D'instructions page 77

WARNING
For information concerning the technical features, warnings and maintenance instruc-
tions consult the related operator manuals provided with the documentation of the
machine.
CAUTION
The machine must not be operated in potentially explosive atmospheres.
The machine is supplied partially disassembled and is to be assembled according to
the procedures described below.
Installing the head and LCD
monitor
- Remove the head rear closing plate
(C, Fig.3);
- Loosen the 4 screws M8 (A, Fig.3) that
fasten the head to the body on the
rear side without unscrewing them
completely;
- Remove the head from the 4 fastening
screws pulling them first towards the
left and then towards the rear side of
the machine;
- Turn the head to a vertical position
and insert the 4 fastening holes on
the M8 screws on the body (B, Fig.3a),
making sure that the previous loos-
ened screws do NOT touch the head
itself;
- Tighten the fastening screws on which
the head is positioned;
- Unpack the monitor and fix it to the
mounting flange with the four screws
supplied with the machine (C, Fig.
3b);
- Connect the signal cable leading
out from below the rear panel of the
machine (F, Fig. 3c) to the monitor
(F, Fig. 3b), connect the power cable
(G, Fig. 3b) to the rear panel (G, Fig.
3c), and feed these cables into the
head;
- Refit the head backing plate removed
previously.
Operator's Manual S 65 E - S 65 E C
3
3a
77