SICE S 65 E Manuel D'instructions page 95

- Change the displayed width value by increasing or decreasing the value using the
keypad.
After updating the wheel data the user can:
1) press the exit
to the new dimensions;
2) press the ENTER button to access the manual dimensions programme to convert and/
or change the wheel data.
- if two subsequent measurements are taken inside the rim on two balancing planes,
the machine interprets the presence of a rim with balancing using a clip weight on
the inner plane and an adhesive weight on the external one (ALU 2P). In this phase,
the machine could automatically change the type of weight on the inner plane from
clip to adhesive (ALU 1P).
Returning the arm to its idle position makes it possible for the operator to change this
setting, selecting and pressing the "enter" key
gramme switches from ALU 1P to ALU 2P and vice versa.
DETECTION PLANS BY
POINTER LaserX
The detection of the geometrical data relative to the real
balancing planes for the application of adhesive weights,
can be facilitated by the laser line on the lever of the au-
tomatic detector.
To enable this line it is necessary to press the button on the
automatic arm (A, Fig.16a).
The laser line is thus visible inside the rim for 10 seconds,
after which, if necessary, the button on the automatic arm
must be pressed again.
Operator's Manual S 65 E - S 65 E C
button to display the unbalance values recalculated according
ALU 2P
(IF PRESENT)
ALU 1P
. In this case, the balancing pro-
16a
95