Machine Set Up Guide - Numatic TRO 650G / 200T Notice Originale

!
PLEASE READ BEFORE COMMENCING ANY OPERATION AFTER THE REMOVAL OF ALL
CONTENTS
1 x Owner Manual
2 x Battery Charging Lead
2 x Keys
3 x 40 Amp Fuse (1 spare)
2 x Side pod skirts
1 x Brake disengage key
1 x Maxi Fuse-puller
Lift top tank assembly to reveal battery compartment.
Always lift between points as illustrated to ensure personal safety.
Fit battery fuses (contained in start-up pack) into the battery fuse holders as illustrated (Fig.1).
Remove transit block from pallet (Fig.2).
!
NOTE: ENSURE THAT NO METAL OBJECTS COME INTO CONTACT WITH BATTERY
WHEN INSERTING THE FIRST FUSE YOU MAY NOTICE A SPARK, THIS IS NORMAL.
3
Insert key into main control (on / off) and turn quarter-turn clockwise to position (1) 'On' (Fig.3).
Ensure that the forward / reverse switch is set to forward (Fig.4).
Depress accelerator pedal with right foot and slowly drive machine off of the pallet using the ramp
provided (Fig.5).
Note: The seat is fitted with a pressure sensor that disables the machine until
an operator is seated.
When the machine is removed and in a safe position, turn key back to the position (0) 'OFF' (Fig.6).
THE PACKAGING, CAREFULLY OPEN AND CHECK THE CONTENTS.
2
TERMINALS WHILE THE BATTERIES ARE EXPOSED.
4
Machine Set-up Guide
1
5
www.numatic.co.uk
!
!
8