Machine Set-Up Guide - Numatic TRG 720/200T Notice Originale

!
PLEASE READ BEFORE COMMENCING ANY OPERATION AFTER THE REMOVAL OF ALL
● Owner manual
● Battery charging lead
● 2 x 40 Amp fuses (200T) /
3 x 40 Amp fuses (300T)
● 30 Amp fuse ● 20 Amp fuse
● 4 Amp fuse ● 2.5 Amp fuse
● Maxi fuse-puller
● 2 x Keys
Lift top tank assembly to reveal battery
compartment, ensuring you use the handle
grip provided.
Fit battery fuses (contained in start-up pack)
into the battery fuse holder as illustrated.
Insert key into ignition located on the
control panel.
NOTE: Wear suitable gloves when
inserting fuses.
Lift fuse cover and Insert battery fuses.
Less battery models - Numatic International Ltd recommends using MK Batteries for the TRG machines mentioned in this manual.
For full battery specifications see page 24.
!
NOTE: DO NOT DEPRESS ACCELERATOR PEDAL WHILE SOFTWARE INITIALISES. The machine will not operate in reverse
with the floor tool lowered. The seat is fitted with a pressure sensor that disables the machine until an operator is seated.
Set direction switch to forward.
THE PACKAGING, CAREFULLY OPEN AND CHECK THE CONTENTS.
1. Use handle grip when
raising or lowering the
top waste tank.
Switch on the machine. Remove the key when
the appliance is not in use.
Set to slowest speed, depress accelerator and
drive off the pallet using ramp provided.
2. Fuses
Battery display panel illuminates to show power.
Once in a safe location switch off machine.

Machine set-up guide

T (+ 44) 01460 68600
!
!
7