Twin Tec Maintenance; Machine Set-Up; Tilting The Handle - Numatic TT 4045 Mode D'emploi

• Only use brushes provided with the appliance or those specified in the instruction manual.
• The use of other brushes may impair safety.
• A full range of brushes and accessories are available for this product.
• Only use brushes or pads which are suitable for the correct operation of the machine for the specific
WARNING
task being performed.
• It is essential that this equipment is correctly assembled and operated in accordance with current
safety regulations.
• When using the equipment always ensure that all necessary precautions are taken to guarantee the safety of the
operator and any other persons who may be affected.
• Wear nonslip footwear when scrubbing. Use a respiratory mask in dusty environments.
• The machine, while charging, must be positioned so that the mains plug is easily accessible.
• When cleaning, servicing or maintaining the machine, replacing parts or converting to another function the power
source shall be switched off.
• Mains operated machines shall be disconnected by removing the power plug, and battery operated machines
shall be disconnected by switching off the isolating key.
• Machines left unattended shall be secured against unintentional movement.
• When detergents or other liquids are used, read the manufacturer's instructions.
• Do not allow the supply cord to come into contact with the rotating brushes.
• Operators shall be adequately instructed as to the correct use of the machine.
Daily
Keep the machine clean
Ensure brushes/ pads/ squeegee/ filters are in good condition
Check for any worn or damaged parts and replace immediately
Drain and rinse dirty water tank after every use
Store machine with brush deck secured in tilted position
Weekly – as daily and –
Check brush or pad and skirt and rinse
Check floor-tool blades for wear and wipe clean
Clean separator assembly including filter and check condition of seal
Flush out system with clean water and clean filters
Do not steam clean or pressure wash
!
PLEASE READ BEFORE COMMENCING ANY OPERATION AFTER THE REMOVAL OF
ALL THE PACKAGING, CAREFULLY OPEN AND CHECK THE CONTENTS.

Tilting the handle

1

Twin Tec Maintenance

Machine Set Up
Using the handle position
lever (Fig.1).
Move the handle into the
upright position (Fig.2).
8
2
!