Preparing The Machine For Operation; Installation Instructions - Stihl MH 700 Manuel D'installation

Item Designation
J Carrying handle
K Screw clamp
L Folding retainer
M Coupler
N Cover
O Transport wheel
P Guard plate holder, left
Q Guard plate holder, right
R Guard plate holder, rear
S Running wheel
T Mount
U1 Bolt M12x40
U2 Bolt M8x30
U3 Bolt M8x65
U4 Bolt M5x12
U5 Bolt M6x50
U6 Bolt M6x16
U7 Special bolt
U8 Bolt M8x20
U9 Bolt M10x25
U10 Bolt M10x30
U11 Bolt M8x55
V1 Washer 12
V2 Washer 10 (thick)
V3 Washer 10
V4 Washer 8 (thick)
V5 Washer 8
V6 Washer 6
V7 Spring washer 10
V8 Spring washer 8
W1 Nut M12
W2 Nut M10
W3 Nut M8
W4 Lock nut M10
W5 Lock nut M8
58
Qty. Item Designation
1 W6 Lock nut M6
2 X1 Pin 12
2 X2 Pin 8
2 Y Spring clip
2 Z Cable tie
1 Instruction manual
1 Engine instruction manual
1 Installation tool
1
7. Preparing the machine for
2
operation
2
2
2

7.1 Installation instructions

4
Risk of injury!
3
Observe the safety instructions in
1
the "For your safety" section. (
8
In particular, detach the spark plug
1
socket and always wear thick
gloves when carrying out any work
4
on the hoes and wheels.
8
2 Observe the specified torque!
1
Drive cables and throttle cable are
2 already installed and attached.
Incorrectly installed cables
8
(e.g. incorrect routing or attaching
4
to the wrong drive lever) may
4
cause malfunctions.
5
● Perform all the operations described on
8
a clean, flat, level and firm surface.
8
● Observe installation positions – always
1
ensure that the machine is standing
2
stably and securely.
4
3
2
8
● Strictly observe instructions for cable
Qty.
installation. In particular, fasten all
8
cables to the handlebar using cable
1
ties in order to prevent damage to the
1
machine (e.g. when folding down the
handlebar) or possible malfunctions.
2
7
1
1
7.2 Installing the right hoe
1
Risk of injury!
Hoes and running wheels must
always be installed in pairs. Never
install a hoe on one side and a
running wheel on the other side.
Strictly observe the installation
instructions. In particular, observe
the installation sequence and install
the hoe and folding retainer
completely as described. When
4.)
installing the folding retainer, strictly
observe the correct direction of
insertion and positioning of the
securing clip, as shown. In the case
of incorrect or rotated installation,
the folding retainer may come loose
and be lost.
For good working results, the
cutting edges of the hoes must
point forwards (not towards the
handlebar) – observe markings.
0478 404 9603 A - EN