Stihl MH 700 Manuel D'installation page 65

● Position throttle cable (1) using cable
clip (2) so that the cable is tucked away
as neatly as possible and not touching
engine components.
7.9 Installing the carrying handle
Risk of injury!
Make sure that the tiller is stable.
● Unscrew bolts (1) together with
washers (2) and nuts (3).
● Discard bolts (1) and nuts (3).
0478 404 9603 A - EN
● Install carrying handle (J) on the basic
unit using bolts (U3), washers (2) and
nuts (W5).
Tightening torque: 35 - 40 Nm
7.10 Installing the guard plate holders
Installing the front right guard plate
holder
● Install front right guard plate holder (Q)
using bolts (U8) and washers (V4).
Installing the front left guard plate
holder
● Install front left guard plate holder (P)
using bolts (U8) and washers (V4).
Installing the rear guard plate holder
● Install rear guard plate holder (R) using
bolts (U10), washers (V3) and
nuts (W4).
63