Stihl MH 700 Manuel D'installation page 62

● Lift basic unit (A) with the help of a
second person.
● Place cover (N) and coupler (M) on
drive shaft (1).
● Tighten the locking screw on
coupler (M).
60
The hoe is marked with a sticker
(L - left).
● Position hoe (B2) so that the bores in
the shaft mount and the drive shaft
align.
● Push hoe (B2) onto the drive shaft.
● Insert folding retainer (L) through the
bore and close the securing clip.
7.4 Installing the running wheels
The running wheels are installed in the
same way as the hoes.
7.5 Installing the transport wheel
● Tilt the basic unit back slightly with the
help of a second person and hold it.
● Fasten transport wheel (O) at the rear
bore with bolt (U5), washer (V6) and
nut (W6).
0478 404 9603 A - EN