Hardware Configuration; Opening The Configuration Door; Dip1 Configuration; Dip2 Configuration - Videotec ULISSE MAXI Manuel D'instructions

8.14 Hardware configuration

8.14.1 Opening the configuration door

Before powering the device it must be configured
correctly by setting the dip-switches inside the
configuration window. Open the hatch by undoing
the screws as shown in figure.
Fig. 65
The DIP-switches appear as shown in the figure.
Fig. 66
After installation and wiring, close the
product again.

8.14.2 DIP1 configuration

When the switch rocker is up it represents
the value 1 (ON). When the dip-switch
rocker is down it represents the value 0
(OFF).
Switch 1 is used to update the firmware.
Switches 4, 3 and 2 are used to select the
communication rate of the device.
Fig. 67
34
DIP1 CONFIGURATION
Description SW SW
4 3
Baud rate OFF OFF
adjustment
ON OFF
OFF ON
ON ON
OFF OFF
ON OFF
OFF ON
ON ON
Firmware update – –
– –
Fig. 68

8.14.3 DIP2 configuration

When the switch rocker is up it represents
the value 1 (ON). When the dip-switch
rocker is down it represents the value 0
(OFF).
The Pan & Tilt can be controlled via various protocols.
Fig. 69
DIP2 CONFIGURATION
Protocol SW SW
8 7
PTZ Manager1 OFF OFF OFF OFF OFF OFF OFF OFF
MACRO OFF OFF OFF OFF OFF ON
(VIDEOTEC)
PANASONIC OFF OFF OFF ON
PELCO D OFF OFF OFF OFF ON
AMERICAN OFF OFF OFF OFF ON
DYNAMICS
VISTA OFF OFF OFF ON
Tab. 13
Deafult configuration: MACRO (VIDEOTEC), 115200
1
baud, Address 1. This option does not require the
setting of the DIP-switch (DIP1, DIP3).
Tab. 14
SW SW Baud rate
2 1
OFF – 300 baud
OFF – 600 baud
OFF – 1200 baud
OFF – 2400 baud
ON – 4800 baud
ON – 9600 baud
ON – 19200 baud
ON – 38400 baud
– ON Set up enabled
– OFF Set up disabled
SW SW SW SW SW
6 5 4 3 2
ON
OFF ON OFF OFF
OFF OFF ON
ON ON
OFF OFF ON
MNVCUPTMAXB_1511_EN
SW
1
ON
OFF
ON