Alarms Menu; Communication Menu - Videotec ULISSE MAXI Manuel D'instructions

10.1.10.1 Alarms Menu

01-04. Alarms 1-4: Access the menus, which
allow you to modify the Alarm parameters from
1 to 4.
05. Alarms State: Access the Alarm Status menu.
ALARM
------------------------
1>ALARM 1
2 ALARM 2
3 ALARM 3
4 ALARM 4
5 ALARMS STATE
Fig. 110
This is a dynamic self-configuration menu based on
the Pan & Tilt model.
The single alarms menu allows you to configure the
following values:
Type: Type of contact, normally closed (N.C.) or
1.
normally open (N.O.).
Action: The type of action carried out by P&T
2.
when the alarm triggers (Off, Msg, PTZ Stop,
Wiper, Washer, Scan, Patrol, Autopan, Relay, Ir
Filt). The OFF parameter disables the alarm.
Number: The preset to be reached when the
3.
alarm's type of action is Scan.
Text: This message is displayed when the alarm
4.
is active.
ALARM 1
------------------------
1>TYPE :
2 ACT. :
3 NR. :
4 TEXT : ALARM 1
Fig. 111
50
>
>
>
>
>
N.C.
SCAN
1
This is a dynamic self-configuration menu based on
the choice made and shows the parameters on which
it is possible to operate.
The Alarm Status menu shows the input status of the
alarms (Closed, Open).
ALARMS STATE
------------------------
ALARM 1
ALARM 2
ALLARME 3
ALLARME 4
Fig. 112

10.1.10.2 Communication menu

Serial ACK: Configure the Pan & Tilt to enable/
1.
disable the sending of an ACK response to the
serial commands.
ACK PELCO D Standard:Configure the PELCO D
2.
command ACK response. The menu is invisible
if the communication protocol set by the DIP
switches is not PELCO D or if the ACK response
is not enabled (SERIAL ACK = FALSE). If the
menu item is enabled, the ACK response is the
standard type (checksum correlated to the
original message). If the menu item is disabled,
the checksum is only calculated on the ACK
package itself.
COMMUNICATIONS
------------------------
1 SERIAL ACK
2 DEFAULT PELCOD ACK : N
Fig. 113
CLOSED
OPEN
CLOSED
CLOSED
: Y
MNVCUPTMAXB_1511_EN