Fixing The Upper Body; Counterweights Installation - Videotec ULISSE MAXI Manuel D'instructions

8.6 Fixing the upper body

Fix the upper body (01) to the base (02) using the
fixing screws (03) equipped with gaskets (04). Make
sure the base seal is present and in good condition
(05).
Pay attention to the fixing. Tightening
torque: 4Nm.
01
05
Fig. 43
Fig. 44
There is one anchoring position between
the base and upper body. Align side
projections to obtain the correct
positioning.
MNVCUPTMAXB_1511_EN

8.7 Counterweights installation

Fasten the counterweights to the housing using the
screws and washers supplied.
02
Fig. 45
04
Apply a thread-locker on the holes of the
03
screws (Loctite 243®).
Pay attention to the fixing. Tightening
torque: 16Nm.
27