Adjusting The Seat; Setting The Cleaning Controls; Important - Numatic TRG 720/200T Notice Originale

Machine set-up guide

Adjusting the seat

Sitting in the driving position, adjust the seat forwards or backwards as necessary by using the lever
found on the left-hand side (see Fig 1, 2, 3).
Note: The seat is fitted with a pressure sensor that disables the machine until an operator is seated.
1

Setting the cleaning controls

When in the area to be cleaned follow the instructions below to set up the machine ready for cleaning.
Sitting in the driving position follow steps 1 - 6.
1
OFF
Insert the key into the ignition and quarter
turn it clockwise to the 'ON' position.
The battery charge level indicator will
illuminate.
!
NOTE: MACHINE WILL NOT REVERSE WITH FLOOR TOOL IN THE LOWERED POSITION.
4
Low
Turn dial to set desired water flow.
The machine is now set up and ready to start cleaning, depress the accelerator pedal to start the cleaning process.
Adjust waterflow and speed according to floor type and level of soiling.
!
2
2
ON
Set direction switch to forward.
High
Lower brush deck
by pushing down
on the pedal,
release handle and
raise foot pedal.
DO NOT OPERATE MACHINE UNLESS THE OPERATOR MANUAL
HAS BEEN READ AND FULLY UNDERSTOOD.
Forward
Reverse
5
Lower floor tool
by lifting lever
upwards.

IMPORTANT

3
3
Slow
Turn dial to set desired cleaning speed.
6
OFF
ON
Press vacuum switch ON to turn on suction.
T (+ 44) 01460 68600
Fast
!
!
15