Wing Installation - Horizon Hobby HANGAR 9 Timber 110 30-50cc Manuel D'utilisation

6. Fit the cowling back on the fuselage. Secure the cowling to the
fuselage using four M3 x 10 socket head cap screws and four M3
rubber washers. Tighten the screws using a 2.5mm hex wrench.
 Refer to checking the blind nuts on Page 5
before installing the screws.
 Place a drop of canopy glue on the screws before
installation. This will keep the screws from vibrating
loose yet leave them easily removable if necessary.
7. If performing extreme aerobatics, it is recommended to secure
the windscreen using two of the M3 thumbscrews as well as the
magnets. Otherwise the front hatch may come loose in fl ight.
8. Secure the propeller (not included) to the engine shaft. Attach the
spinner cone (not included) using the screws provided with the
spinner. Trim the openings around the propeller if necessary, as the
propeller must not come in contact with the spinner cone when
installed.
9. Secure the top hatch to the fuselage using two M3 thumbscrews or
two M3 x 10 socket head caps screws and two M3 washers.
 Refer to checking the blind nuts on Page 5
before installing the screws.
 Place a drop of canopy glue on the screws before
installation. This will keep the screws from vibrating
loose yet leave them easily removable if necessary.
10. Secure the side hatch using four M3 x 10 socket head caps screws
and four M3 washers.
 Refer to checking the blind nuts on Page 5
before installing the screws.
 Place a drop of canopy glue on the screws before
installation. This will keep the screws from vibrating
loose yet leave them easily removable if necessary.
EN

WING INSTALLATION

1. Slide the wing tube into the wing tube socket.
 The wing tube may be a tight fit in the socket. Polishing
the wing tube with fine sand paper or steel wool will
help ease the installation of the wing tube.
2. Slide the wing into position on the fuselage. Guide the leads for the
ailerons and fl aps into the fuselage.
3. Slide the wing tight against the fuselage side while guiding the
wiring inside the fuselage.
4. Secure the wing to the fuselage using two nylon wing bolts.
 The nylon bolt can be shortened to 1
3
/
8
(55mm) to make securing the wing easier.
5. Repeat the previous steps to attach the remaining wing panel.
24
inches