Battery Charging; Led Indications; Wing Installation - Horizon Hobby E-flite Bind-N-Fly UMX FPV RADIAN Mode D'emploi

Battery Charging

LED Indications

CHARGING
(Solid Red)
MAX CHARGE ...................................
(off)
CAUTION: Never exceed the recommended
charge rate.
CAUTION: Charge only batteries that are cool
to the touch and are not damaged. Look at the
battery to make sure it is not damaged e.g.,
swollen, bent, broken or punctured.
CAUTION: Always disconnect the fl ight
battery from the charger immediately upon
completion of charging.
Charging a fully discharged (not over-discharged)
150mAh battery takes approximately 30-45
minutes at the charger's 300mA charge rate.

Wing Installation

1. Slide the wing into the wing slot on the
fuselage until the holes line up with the screw
holes on the bottom.
2. Secure the wing using 2 screws.
3. Cut the loop tape (A) into 3 pieces and apply
them around the screws in the battery holder,
as shown.
..............................
USB Li-Po
Charger
DC Input:5.0V 350mA
DC Output:4.2V 300mA
SOLID RED LED
–Charging
USB Li-Po LED OFF
Charger –Charge
Complete
DC Input:5.0V 350mA
DC Output:4.2V 300mA EFLC1008
SOLID RED LED
–Charging
USB Li-Po LED OFF
Charger –Charge
Complete
DC Input:5.0V 350mA
DC Output:4.2V 300mA EFLC1008
A
SOLID RED LED
–Charging
LED OFF
–Charge
Complete
EFLC1008
45
MIN.
EN
5