Rudder Servo Installation - Horizon Hobby HANGAR 9 Timber 110 30-50cc Manuel D'utilisation

10. Use contact cement or two-sided tape to attach the landing gear
cover to the fuselage. Using tape allows the cover to be removed
for maintenance or to replace the landing gear or upgrade to the
optional fl oats or tundra gear in the future.
Optional Landing Gear Fairing
11. An optional landing gear fairing has been included and is glued to
the landing gear using fl exible adhesive. Use a clamp to hold the
landing gear fairing in position. Allow the adhesive to fully cure
before continuing the build of the model.
 The landing gear fairings are not recommended when
flying from rough surfaces as the gear will flex and
the fairings may release from the landing gear.
EN

RUDDER SERVO INSTALLATION

1. Remove the hatch from the side of the fuselage.
2. Remove the hatch from the top of the fuselage.
3. Install the rudder servo in the fuselage with the output toward the
front of the fuselage. Make sure to harden the mounting screw
locations with thin CA before installing the servo.
4. Thread the servo ball end on the cable fi tting. Thread the ball end
ten turns to make sure it is secure, and this allows for adjustment to
tighten the cables later. Prepare two servo ball ends.
 Prepare the two ball ends and cable fitting for the control horns.
5. Center the rudder servo using the radio system. Fit a 3 inch (76mm)
rudder servo arm on the servo so it is perpendicular to the servo
center line. Rotate the arm 180-degrees to get the closest position if
required. Use the sub-trim function on the transmitter to make any
fi nal adjustments. Mark the servo arm so it can be returned to its
location, then remove it from the servo.
14