Flap And Aileron Servo Installation - Horizon Hobby HANGAR 9 Timber 110 30-50cc Manuel D'utilisation

FLAP AND AILERON SERVO INSTALLATION

1. Secure an 18-inch (460mm) servo extension to the servo using a
commercially available retainer (SPMA3054).
 The length of the extension may vary depending on servo selection.
The extension listed works with the recommended servos.
2. Tie or tape the string located inside the wing to the end of the servo
lead.
3. Use the string to pull the servo lead through the wing and out at the
root.
 We left a small amount of the string on the aileron
servo lead so it can be quickly differentiated between
the flap servo lead that will be installed later.
4. Fit the servo in the wing with the servo output toward the leading
edge. The servo arm will be centered in the opening. Mark the
locations for the servo mounting screws using a pencil, then remove
the servo.
5. Use a pin vise and a 5/64-inch (2mm) drill bit to drill the holes for
the servo mounting screws in the locations marked in the previous
step.
 If using a drill, make sure not to drill through
the covering on the top of the wing.
Timber 110 30–50cc ARF
6. Thread a servo mounting screw into each of the holes in the servo
mounting holes.
7. Remove the screws, then apply a small amount of thin CA to harden
the threads made in the previous step.
8. After the CA has fully cured, secure the servo to the cover using the
screws provided with the servo.
9. Repeat the previous steps to install the fl ap servo in the wing
10. Assemble the linkage for the aileron. Make sure to use one of each
type of ball end when assembling the linkage. Thread each ball end
12 turns on the link.
 The link is designed to be adjustable. The
threads on one end are reversed.
9 EN