Prefl Ight; Model Assembly; Wing Installation - Horizon Hobby Force RC F-18 Blue Angel Manuel D'utilisation

EN
Prefl ight
1 Remove and inspect contents.
2 Read this instruction manual thoroughly.
3 Charge fl ight battery.
4 Fully assemble airplane.
5 Install the fl ight battery in the aircraft (once it has been fully charged).
6 Check the Center of Gravity (CG).
7 Bind aircraft to your transmitter.

Model Assembly

Wing Installation

1. Slide the wing tube into the fuselage.
2. Slide the wing panels (A) on the wing tube. Ensure the wing panels are tight
against the fuselage.
3. Install 4 screws (B) to secure the main wing panels into place.
4. Attach the clevis to the aileron control horn (see instructions for clevis
connection).
5. When needed, disassemble in reverse order.
Horizontal Stabilizer Installation
1. Apply CA to the base of the horizontal stabilizer where it meets the
fuselage.
2. Apply CA in the slot in the fuselage where the horizontal stabilier fi ts.
3. Fit the horizontal stabilizer in the slot. Ensure the control horn faces down
toward the bottom of the fuselage.
Make sure the horizontal stabilizer is aligned with the wing. Adjust as
necessary before the CA fully cures.
4
8 Make sure linkages move freely.
9 Perform the Control Direction Test with the transmitter.
10 Perform the AS3X Control Direction Test with the aircraft.
11 Adjust fl ight controls and transmitter.
12 Perform a radio system Range Test.
13 Find a safe open area to fl y.
14 Plan fl ight for fl ying fi eld conditions.
3mm X 10mm
F-18 Blue Angel
A
B